I like to share some of my mom's roses.
This is a closed up shot of the miniature rose. Next to this rose, on the left is the Samba Kordana.
This is another of her tropical rose collection
***
I remove older rose canes if there are other younger replacement canes. According to the rule of thumb, the ideal number of canes is five. If there are more than 5 and they are well distributed I leave them alone. If there are only a couple of good ones and some old tired canes. I just keep the good ones. The fresh cuts often spur new can growth. I don't want them leaning on one another as the rubbing produces entry points for disease. A healthy young cane is generally green or reddish. There are three healthy young canes on this rose. The remaining three gray canes are two years old. I will keep them for another season if they are still producing strong growth at the top. Keeping the center of the plant open so that air passes through helps prevent fungal attacks. I will score the bud union when I think that desperate measures are required and I am convinced that the risk of wounding the cambium is worth improving the chances of a new cane breaking through at the wound site.
The size of the rose bush is dependent upon the variety of the rose and the health of the roots. If a rose is cut back severely it will recover. This knowledge can give you the confidence to do the right thing. A large plant has a large set of roots. They will have the energy to rapidly replace the parts that have been removed. Since so many of the David Austin Roses are so large I tip prune them until they flower and then remove the end of the cane to where the new growth sprouts out.
click here to continue with the rose pruning primer (the perfect cut)
***
I have found the best gauge to decide how much to prune is by estimating the 'strength' of plant roots beneath the soil
One of the ways you can estimate the strength of your plant roots is by measuring the diameter size of the main stem. The thicker/bigger the main stem is, the stronger the roots. However this way of measuring has an exception, that is if this rose plant was recently propogated from cuttings, the roots may not be as established.
How do I determine the shrub size that can have the right balance of nutrients uptake and consumption?
For example, a rose that has potential to grow up to 1 metre in height and main stem up to 3 cm diameter. We can work out the height to prune down by working the ratio of current stem diameter over the fully grown one.
For example, the current stem diameter is measured at 1cm. That means the correct height should be
1cm x 100cm / 3cm = 33.33cm should be the ideal height/size.
Therefore prune about 30% (10cm) of the 33.33cm to create room for growth to reach ideal height/size.
As you get the hang of it, you will know how much to prune at the mid-height of the plant. Generally the rule of thumb is to remove thin, small and unhealthy stems at the mid-height of plant, to create more room for growth. The same principle applies.
I must be willing to give up what I am in order to become what I will be
Einstein
If you prune your rose shrub to lower than ideal height/size, it will ensure many stronger, fuller and healthy bush growth.
***

In the following, I like to share some changes made that I believe may help improve the soil structure.
I learned by adding perlite into the mixture it improves water drainage dramatically. I extracted the description of Perlite material as below.
Perlite is a unique volcanic mineral which expands from four to twenty times its
original volume when it is quickly heated to a temperature of approximately
1600-1700 degrees F. This expansion is due to the presence of two to six percent
combined water in the crude perlite rock which causes the perlite to pop in a
manner similar to that of popcorn.When expanded, each granular, snow-white
particle of perlite is sterile with a neutral pH and contains many tiny, closed
cells or bubbles. The surface of each particle is covered with tiny cavities
which provide an extremely large surface area. These surfaces hold moisture and
nutrients and make them available to plant roots.
In addition, because of
the physical shape of each particle, air passages are formed which provide
optimum aeration and drainage. Because perlite is sterile, it is free of
disease, seeds, and insects.
The other changes were the soil medium material that I used. I tried compost with mixtures of sand and silt in it; which is also known as Sandy Loam mixture. This helps improve a lot in drainage especially if it is exposed to heavy rain fall. I noticed for soil mixture without Sandy Loam mixture, the soil structure changed during rainy months. The soil became more compact and the heavier soil properties tend to make its way to the lower base, thus increased water retention and may impede water drainage at the base.
When soil is compact, soil aeration is reduced thus changes the organism metabolic activities in the soil. Lesser air in soil, raises anaerobic activities. The increased of anaerobic activities will affect the soil pH and eventually affect the nutrients availability for the roots.
Some of the symptoms of lack balanced nutrients are leaves defoliate rapidly, new buds turn black, some stems may suffer dieback and many leaves turning yellow.
The above is the improved version.
I realised each supplier/producer package the peat moss differently. Some of them are pre-mixed with compost, that makes up to soil pH of 6. However there are some that is not pre-mixed with compost, therefore their soil pH could go as low as pH 4.5 to 5. It is always good to check the peat moss pH before using for top soil layer.
The correct top soil layer should have a pH 6, slightly acidic.
In my earlier posting, I mentioned using 50% of peat moss for top soil layer, that is because the peat moss that I purchased was pre-mixed with compost, the pH was slightly acidic.
If your peat moss is less than pH6, then it is advisable to mix it with some compost, otherwise the soil will be too acidic and may stunt the growth.
Apart from using brown mulch, coconut powder can also be applied if loose brown mulch is not available. The objective of including brown mulch or coconut powder in the mixture is too loosen the soil and provide some additional organic material to fuel soil organism activities for decomposition.
Hi... my name is Richard Chew. I didn't really started off gardening
because .... more
|
|
| Subscribe to Rose Growing Malaysia |
| Visit this group |